BT35-11-8/380V 工廠倉庫辦公室住宅內通風換氣防爆軸流風機管道式依客思
Bt35-11-8/380v Factory warehouse office residential ventilation explosion-proof axial-flow fan pipe ekesiBT35-11-8/380V 工廠倉庫辦公室住宅內通風換氣防爆軸流風機管道式依客思→風機安裝說明
◆ 安裝前應詳細檢查風機是否有損壞變形,如有損壞變形,待修理妥善后,方可進行安裝。
◆ 安裝時要注意檢查各不如部分有無松動,葉片與風筒間隙應均勻,不得相碰。
◆ 連接風口管道的重量不應由風機的風筒承受,安裝時應另加支撐。
◆ 在風機風口端必須裝集風器,并安裝防護網。
◆ 風機底座必須與地基平面自然接合,不得敲打底座強制聯接,以防底座變形,安裝時應校正機座,加墊鐵片、保持水平位置,然后擰緊地腳螺栓。
◆ 安裝完畢后,必須先進行實驗,待運行正常后,才允許正式使用。
Bt35-11-8/380v Factory warehouse office residential ventilation explosion-proof axial flow fan pipe type yikeisi fan installation instructions
Before installation, check whether the fan is damaged or deformed. If there is damage or deformation, it can be installed only after proper repair.
The installation should pay attention to check whether the parts are loose, blade and air duct clearance should be uniform, not to touch.
The weight of the pipe connecting the tuyere should not be borne by the air duct of the fan, and should be supported during installation.
The air collector must be installed at the tuyere end of the fan and the protective net must be installed.
◆ The fan base must naturally engage with the foundation plane. It is not allowed to force the connection by beating the base to prevent the base from deformation. During installation, the base should be corrected, and iron plates should be added to keep the horizontal position, and then the anchor bolts should be tightene
After the installation, you must carry out the experiment first, until the normal operation, to allow formal use.